SIEMENS
7/21
Siemens NC 62 · 2016
MOTION-CONNECT connection systems
Signal cables for SINAMICS S120
7
■
Overview
MOTION-CONNECT DRIVE-CLiQ signal cable with IP20/IP67 connector
Signal cables are pre-assembled and are sold by the meter for
the connection of a variety of components.
The following different types of cable are available:
•
DRIVE-CLiQ signal cables
•
MOTION-CONNECT DRIVE-CLiQ signal cables
•
MOTION-CONNECT pre-assembled signal cables
Type of delivery for pre-assembled signal cables
Pre-assembled signal cables are available in units of 10 cm
(3.94 in).
The cables are supplied on reels up to 30 kg or 100 m (66.2 lb
or 328 ft). Above 30 kg or 100 m (66.2 lb or 328 ft), cable drums
are used instead of reels.
■
Application
DRIVE-CLiQ signal cables without 24 V DC cores
are used to connect components with DRIVE-CLiQ connections
which have a separate or external 24 V DC power
supply.
MOTION-CONNECT DRIVE-CLiQ signal cables
with 24 V DC cores
are used whenever components with DRIVE-CLiQ connections
must meet high requirements such as mechanical stress and oil
resistance, e.g. where a connection is made outside the cabinet
between Power Modules/Motor Modules and SIMOTICS S-1FK7/
SIMOTICS M-1PH8 motors with DRIVE-CLiQ interface.
MOTION-CONNECT pre-assembled signal cables
are used whenever motor encoders on motors without
DRIVE-CLiQ interface are connected to Sensor Modules.
■
Design
If pre-assembled signal cables are to be installed in a cable
carrier in such a way that the connector would inhibit assembly,
pre-assembled cables without assembled connector can also
be supplied. In this case, the contacts of the cables are crimped
and the connector enclosure is supplied separately. After
installing the cables, the customer assembles the connector
enclosure.
The 6FX.002-2
....
-
....
signal cables are available with crimped
contacts and with the connector enclosure supplied separately
(not for DRIVE-CLiQ signal cables or signal cables with exposed
core ends).
Signal cables with separately supplied
module-end
connector
enclosure. In this case, the 6th position of the Article No. must be
changed from
0
to
1
:
6FX.0
1
2-2C...-
....
(not for signal cables for connection via
terminals or 6FX.002-2AH00-
....
, 6FX.002-2CA12-
....
).
Signal cables with separately supplied
motor-end
connector
enclosure. In this case, the 6th position of the Article No. must be
changed from
0
to
4
:
6FX.0
4
2-2C...-
....
(not for signal cables for connection via
terminals or 6FX8002-2BA20-
....
, 6FX8002-2BA21-
....
).
Note:
Once the contacts have latched into the insulator, they can no
longer be removed.
© Siemens AG 2016