SIEMENS
7/5
Siemens NC 62 · 2016
MOTION-CONNECT connection systems
Introduction
General information
7
■
Function
(continued)
MOTION-CONNECT cables are tested in a cable carrier. The
cables are attached at one end by means of strain relief to the
moving ends of the cable carrier. Strain relief is applied over a
wide area of the cable jacket surface without crimping the cable.
Cables must be installed in accordance with the instructions
supplied by the cable carrier manufacturer.
Notes
:
If, for example, pre-assembled cables are installed in a cable
carrier in such a way that the connector would inhibit assembly,
pre-assembled cables without assembled connector can also
be supplied (power and signal cables
1)
). In this case, the con-
tacts of the cables are crimped and the connector enclosure is
supplied separately. After installing the cables, the customer
assembles the connector enclosure.
In case of vibration load and with horizontal or vertical cable
entries, we recommend that the cable is additionally fixed if
between the cable strain relief on the cable carrier and the
terminal at the motor part of the cable is hanging loose or is not
routed. To prevent machine vibrations being transmitted to the
connectors, the cable should be fixed at the moving part where
the motor is mounted.
Representation in connection overviews
1)
Not in the case of DRIVE-CLiQ signal cables.
■
Characteristic curves for MOTION-CONNECT 800PLUS
The shaded area beneath the characteristic represents the
potential range of use for the cables. The characteristic curves
represent the tested operating points.
Permissible acceleration for signal and power cables
MOTION-CONNECT 800PLUS up to 16 mm
2
Permissible acceleration for power cables
MOTION-CONNECT 800PLUS of 25 mm
2
, 35 mm
2
and 50 mm
2
Symbol
Explanation
Connector with pin contacts
Connector with socket contacts
Exposed core ends
G_NC01_XX_00292
Traversing path
MOTION-CONNECT 800PLUS
Acceleration
G_NC01_EN_00456
v
= 300 m/min
m
m/s²
30
50
40
20
10
0
55
50
45
40
35
30
25
20
15
10
5
0
v = 300m/min
Traversing path
MOTION-CONNECT 800PLUS
Acceleration
G_NC01_EN_00457
v
= 300 m/min
22.5
17.5
12.5
7.5
2.5
m
m/s²
30
50
40
20
10
0
20
15
10
5
0
© Siemens AG 2016