SIEMENS
5/19
Siemens NC 62 · 2016
5
SINAMICS S120 drive system
Engineering software
STARTER commissioning tool
■
Integration
Data can be exchanged (depending on the version) via
PROFIBUS or PROFINET/Ethernet or via a serial interface.
For commissioning and service, a PG/PC can be connected to
the CU320-2 Control Unit via PROFIBUS. A PROFIBUS connec-
tion must be available with a connecting cable at the PG/PC.
Further, communication between a CU320-2 Control Unit and
PG/PC can also be established via Ethernet, either via an
(optional) CBE20 Communication Board or the Ethernet inter-
face -X127 on the CU320-2 Control Unit.
Note:
The terminal strip -X127 is suitable as a communication link to
the PG/PC only for the purposes of servicing and commission-
ing.
■
Selection and ordering data
■
Accessories
Depending on the version of the Control Unit (CU), the Control
Unit of the drive unit can communicate with the programming
device (PG) or PC via PROFIBUS or PROFINET/Ethernet or via
a serial interface. The following accessories are available for the
particular drive system as listed in the following table.
■
More information
The STARTER commissioning tool is also available on the
Internet at
/starter
Description
Article No.
STARTER commissioning tool
for SINAMICS and MICROMASTER
English, French, German, Italian,
Spanish
6SL3072-0AA00-0AG0
Description
Recommended accessories
For communication between the drive unit and the programming device or PC
Article No.
SINAMICS S110/S120
• RS232
SIMATIC S7 connecting cable
Null modem cable, 6 m (19.7 ft)
6ES7901-1BF00-0XA0
• PROFIBUS
CP 5711 communications module
USB adapter for connecting a PG or notebook to PROFIBUS or MPI
USB cable (2 m (6.56 ft)) included in scope of supply
6GK1571-1AA00
SIMATIC DP plug-in cable
12 Mbaud, for PG connector, pre-assembled with 2 × 9-pin sub D connector,
3 m (9.84 ft)
6ES7901-4BD00-0XA0
• PROFINET/Ethernet
Standard CAT5 Ethernet cable or PROFINET cable
–
© Siemens AG 2016