SIEMENS
9/87
Siemens D 21.4 · 2017
SIMOTICS main motors
SIMOTICS M synchronous motors for SINAMICS S120
SIMOTICS M-1FE built-in motors
9
■
Overview
SIMOTICS M-1FE1 synchronous built-in motors
SIMOTICS M-1FE2 built-in motors
The SIMOTICS M-1FE built-in motors are water-cooled synchro-
nous motors that are supplied as stator and rotor components.
When the stator and rotor have been mounted to the spindle in
the spindle box, a complete spindle unit is created.
■
Benefits
7
Compact design (e.g. for turning machines and vertical mill-
ing machines) by dispensing with mechanical components,
such as motor switch armature, belt drive, gearbox and
spindle encoder
7
High power density thanks to water cooling
7
Maximum speeds up to 40000 rpm, torques up to 1530 Nm
(1128 lb
f
-ft) in S1 duty
7
Higher torque – up to 60 % – with the same active component
volume, consequently more compact machine design
compared to SIMOTICS M-1PH2 (asynchronous motors)
7
Extremely short ramp-up and braking times (50 %) thanks to
higher torque compared to SIMOTICS M-1PH2
7
Cold rotor due to excitation using permanent magnets
in the lower speed range and lower power losses in the rotor,
resulting in reduced bearing temperature rise and spindle
expansion
7
The stator and rotor are
ready to install
, no finishing is
necessary
7
The absence of drive transverse forces permits extremely high
accuracy on the workpiece thanks to smooth, accurate
spindle motion even at very low speeds
7
Larger rotor inner bore than squirrel-cage rotor of asynchronous
motors, but with the same outer diameter – advantageous with
regard to the bar capacity of automatic turning machines and
resulting in higher spindle stiffness due to larger shaft diame-
ters for milling spindles
7
Increased rigidity of the spindle drive, achieved by mounting
the motor components between the main spindle bearings
7
Less cooling capacity required for the same power compared
to SIMOTICS M-1PH2, i.e. greater efficiency
7
Only one encoder (hollow-shaft measuring system) for
sensing motor speed and spindle position
7
Simple servicing by replacing complete motor spindles
7
Compatible system of SINUMERIK, SINAMICS S120 and
motor, therefore fast commissioning is ensured
7
Higher machine productivity:
The permanently excited motor spindles (PE spindles)
increase the power density and economic efficiency of CNC
machines. The optimized combination of SIMOTICS M-1FE1
built-in motor, drive control and CNC offers further opportuni-
ties for rationalization, such as shorter workpiece machining
times and fewer clamping faces.
© Siemens AG 2017