![](https://www.globalindustrialsupplies.eu/wp-content/uploads/2016/08/siemens-gallery-4-324x200.jpg)
9/6
Siemens D 31 · 2015
9
SINAMICS S110 servo drives
0.12 kW to 90 kW (0.16 hp to 125 hp)
SINAMICS S110 servo drives
■
Configuration
The following electronic configuring aids and engineering tools
are available for the SINAMICS S110 servo drives:
Drive Technology Configurator (DT Configurator) within
the CA 01
The interactive catalog CA 01 – the offline Industry mall of
Siemens on DVD-ROM contains over 100,000 products with
approximately 5 million possible drive system product variants.
The Drive Technology Configurator (DT Configurator) has been
developed to facilitate selection of the correct motor and/or
inverter from the wide spectrum of drives. It is integrated as a
selection tool in Catalog CA 01.
Online DT Configurator
In addition, the DT Configurator can be used in the Internet with-
out requiring any installation. The DT Configurator can be found
in the Siemens Industry Mall at the following address:
/dt-configurator
SIZER for Siemens Drives engineering tool
The SIZER for Siemens Drives engineering tool makes it easy to
engineer the SINAMICS and MICROMASTER 4 drive families.
It provides support when selecting the hardware and firmware
components necessary to implement a drive task. SIZER for
Siemens Drives is designed to support configuring of the entire
drive system.
Additional information on the SIZER for Siemens Drives
engineering tool is provided in the chapter Engineering tools.
The SIZER for Siemens Drives engineering tool is available free
on the Internet at
/sizer
STARTER commissioning tool
The STARTER commissioning tool allows menu-prompted
commissioning, optimization and diagnostics. Apart from the
SINAMICS drives, STARTER is also suitable for
MICROMASTER 4 devices.
Additional information on the STARTER commissioning tool is
provided in the chapter Engineering tools.
Additional information about the STARTER commissioning tool is
available on the Internet at
/starter
Drive ES engineering system
Drive ES is the engineering system that can be used to integrate
the communication, configuration and data management func-
tions of Siemens drive technology into the SIMATIC automation
world easily, efficiently and cost-effectively. The STEP 7 Manager
user interface provides the ideal basis for this. A variety of soft-
ware packages are available for SINAMICS – Drive ES Basic,
Drive ES SIMATIC and Drive ES PCS.
You can find further information on the Drive ES engineering
system in the section Engineering Tools.
Additional information about the Drive ES engineering system is
available on the Internet at
/drive-es
© Siemens AG 2014