![](https://www.globalindustrialsupplies.eu/wp-content/uploads/2016/08/siemens-gallery-4-324x200.jpg)
7/17
Siemens D 31 · 2015
7
■
Accessories
SINAMICS G110D distributed inverters
0.75 kW to 7.5 kW (1 hp to 10 hp)
Supplementary system components
Manual local control with keyswitch
Example: SINAMICS G110D and manual local control with integrated
keyswitch
The manual local control is a simple method to locally control
and commission the SINAMICS G110D distributed inverter.
To switch over from the automatic to the manual mode or to
switch off the inverter, there is a keyswitch from which the key
can be withdrawn in each of the three operating modes (Auto/
Off/Local).
•
The inverter is controlled via the PLC in "Auto" mode
•
In the "Off" state, the device is shut down (however, the line
supply voltage is still connected)
•
The drive is locally and directly controlled in the "Local"
setting. The device is simply controlled using directly
assigned buttons. The following functions can be selected:
- Switching over between continuous operation/jog mode
- On/Counter-clockwise
- On/Clockwise
- Deactivate Quick Stop
The manual local control is mounted on the inverter instead of
the standard blanking cover. This means that it can be retrofitted
at a later date.
Selection and ordering data
Memory card
SINAMICS memory card (SD card)
The parameter settings for an inverter can be stored on the
SINAMICS SD card. When service is required, e.g. after the in-
verter has been replaced and the data have been downloaded
from the memory card, the drive system is immediately ready for
use again. The card holder is not included in the scope of supply
of the inverter and must be separately ordered.
Selection and ordering data
Description
Article No.
Manual local control with keyswitch
6SL3555-0PL00-2AA0
Description
Article No.
SINAMICS memory card (SD card)
6SL3054-4AG00-2AA0
© Siemens AG 2014