SIEMENS
1/15
Siemens D 84.9 · 2015
1
Introduction
Options
Description of options
■
Overview
(continued)
1)
Not available for SH630
2)
Possible only in horizontal position with special bearings for testing
3)
Does not contain measurement of short circuit characteristic for SH630
Order Code
Description
Remark
Testing
F01
Factory routine test, witnessed
F14
Plot of the no-load characteristic and determining the iron and friction losses, unwit-
nessed
F15
Plot of the no-load characteristic and determining the iron and friction losses, wit-
nessed
F16
Measurement of locked rotor characteristic and determining of locked rotor losses,
unwitnessed
1)
F17
Measurement of locked rotor characteristic and determining of locked rotor losses,
witnessed
1)
F26
Measurement of dielectric loss factor (tan delta) on built-in stator winding, unwit-
nessed
F27
Measurement of dielectric loss factor (tan delta) on built-in stator winding, witnessed
F28
Noise measurement under no-load conditions, without noise analysis, unwitnessed
F29
Noise measurement under no-load conditions, without noise analysis, witnessed
F34
Plot of the current and torque characteristic when accelerating, unwitnessed
1)
F35
Plot of the current and torque characteristic when accelerating, witnessed
1)
F38
Overspeed test, unwitnessed
1)
F39
Overspeed test, witnessed
1)
F52
Measurement of the starting torque and starting (inrush) current, unwitnessed
1)
F53
Measurement of the starting torque and starting (inrush) current, witnessed
1)
F82
Type test with heat run for horizontal motors, unwitnessed
3)
F83
Type test with heat run for horizontal motors, witnessed
3)
F92
Type test with heat run for vertical motors, unwitnessed
2) 3)
F93
Type test with heat run for vertical motors, witnessed
2) 3)
© Siemens AG 2015