SEW EURODRIVE
59
SERVICES
Features
–
The perfect sensor to determine the remaining life
of the gear unit oil and reliably indicate the right
time for an oil change
–
A thermal sensor installed in the gear unit mea-
sures the oil temperature and sends this informa-
tion to an evaluation unit, which then calculates
the time remaining until the next oil change for
the specified oil type
–
The diagnostic unit takes the oxidation character-
istics of the different oils into account under ther-
mal stress
BeneIts
–
Reduction in oil costs
–
Full utilization of the oil service life
–
Startup can be performed directly on the diagnos-
tic unit (without PC)
–
Simple identification and reading of the time re-
maining until the next oil change
–
5 different oil grade can be parameterized
–
A warning message is issued if predefined limit
values such as the maximum oil temperature are
exceeded
–
Permanent monitoring of oil aging
–
Maintenance intervals can be planned individually
Diagnostic Unit OiL Aging
Gear unit oiL diagnostics through
thermaL anaLysis
Diagnostic unit DUO
Features
–
Ideal sensor to monitor the wear and proper func-
tioning of the brake (BE../ BF.. / BT..)
–
Measuring system for contactless monitoring of
the working air gap
–
A single sensor reliably monitors both the correct
functioning of the brake and the wear of the lining
BeneIts
–
Brake lining wear can be detected in good time
–
Reliable brake function monitoring
–
Contactless and thus wear-free measuring system
–
Evaluation directly via SEW-EURODRIVE frequency
inverter with corresponding error protocol
–
Can be used in damp conditions up to IP66
–
Maintenance intervals can be planned individually
according to wear
Features
–
Ideal sensor to monitor the wear and proper func-
tioning of the brake
–
The voltage-dependent signal can be evaluated
by an SEW-EURODRIVE frequency inverter or a
higher-level controller
–
Two sensors can reliably monitor both the correct
functioning of the brake and the wear of the lining
BeneIts
– Brake lining wear can be detected in good time
–
Reliable brake function monitoring
–
The condition signal of the microswitch can be
implemented as a normally closed (monitoring
wear) or normally open (monitoring proper func-
tioning) contact
–
Easily processed voltage-dependent output signal
–
Evaluation directly via SEW-EURODRIVE frequency
inverter with corresponding error protocol
–
Can be used in damp conditions up to IP65
–
Self-cleaning contacts inside the sensor
–
Maintenance intervals can be planned individually
Diagnostic Unit Eddy Current
Brake diagnostics with continuous
function and wear monitoring
Diagnostic Unit Brake
Brake monitoring
NEW:
Diagnostic unit option /DUE
Diagnostic unit option /DUB